Views: 0 Author: Site Editor Publish Time: 2025-03-14 Origin: Site
Fire Engine Operation Guide
Operating a fire engine truck requires proper knowledge of its functions, maintenance, and safety precautions. Below is a detailed guide on how to operate, maintain, and handle a fire engine truck efficiently.
Starting and Stopping the Fire Engine: Begin by pressing the clutch, turning on the ignition, and releasing the clutch to start the power system. Open the rear intake valve, activate the fire engine pump, wait 1-2 seconds, and then open the outlet valve.
Shutting Down the Fire Pump: First, turn off the fire engine pump, then close the rear intake valve, switch off the power, and finally shut the outlet valve.
Foam Operation: Activate the power, open the rear intake valve, start the fire engine pump, wait 1-2 seconds, and then engage the foam supply. Turn on the foam induction switch and activate the foam proportioning mixer for automatic mode. If manual operation is required, turn on the manual switch.
Winter Operations: To prevent brake failure due to frozen air lines, regularly replace the drying canister. Apply grease inside the fire engine water tank outlet and ensure proper insulation on the outer section.
High-Altitude Operations: When using an aerial ladder platform fire engine, fully extend all four stabilizer legs. Ensure the vertical supports are placed on a solid surface and the vehicle is leveled. Use safety ropes to stabilize the platform when the wind speed exceeds level 5. If wind speeds exceed level 6, cease operations immediately.
Routine Maintenance: After cumulative usage, clean the fuel tank filter, fire engine water tank filter, inspect the electric fire engine’s circuit integrity, transmission box, gearbox lubrication, safety valves, gears, fuel tank, waterway valves, ceramic plunger pump, boiler coils, and control circuits.
Winter Maintenance: In cold weather, check and replace the diesel heater switch, apply grease on the outlet valve, and inspect the torch and heating bottle to ensure the airport fire engine operates smoothly in low temperatures.
Prioritizing Safety: Operators must carry a portable combustible gas detector before starting the fire engine truck. Conduct a thorough check to ensure no gas leaks before ignition.
Pre-Operation Vehicle Inspection: Before use, conduct a full inspection of the fire engine car to ensure no mechanical failures or defects. Do not operate the vehicle if any issue is detected.
Cable Inspection: Before operation, inspect the electrical wiring of the remote control fire engine truck. If any exposed, damaged, or aging wires are found, replace them before proceeding.
By following this guide, operators can ensure that fire engine trucks, including electric fire engines and fire engine lights, function safely and efficiently in various conditions. Whether you are considering a fire engine truck for sale or operating one in emergency scenarios, these guidelines help maximize performance and longevity.